Those of you who have been around here for a while know how much I love working with bias. (You can see some previous projects in my Modern Bias collections on Pinterest or Flickr). It feels like I haven't done a bias project for a while and its light, airy feel is perfect for Spring.
White Diamonds table runner in the new issue of Modern Patchwork. It just feels so fresh!
So, let me tell you how I got from Snowflake to Daisy.
Makes a 16" pillow.
1/2 yard Robert Kaufman Kona Peridot
1/2 yard Robert Kaufman Kona White
Trim the Peridot to 16 1/2" square for the background.
Cut 6 one inch wide bias strips from the white, plus two 4 1/2" squares.
|Pressed lines/circle template|
(In the picture, I haven't yet folded the right side of the bias strip over).
With the raw edge against the background, pin the bias strips in place over the marked lines. Be sure the ends extend into the circle just a little bit so the circle will cover them. Stitch the bias strips in place along the long edges. Remove the basting.
A couple of notes about this picture - I originally planned to make the pillow in this orientation but, when I'd finished it, I liked it better turned a quarter turn. As the WIP sat on my design wall, I began to like the open center. I stitched a few rounds of white stitching where the center was planned to see if I should leave it like that. In the end, I decided I liked the solid center best.
Press the circle template onto the wrong side one of the 4 1/2" white squares (With solids, there really is not right and wrong side - so many errors avoided!). Trace around the circle. Place the second white square right sides together with the first one and, using small stitches, stitch on the traced line. Trim the seam allowance to about 1/8". Carefully cut a slit in one of the circles and turn the piece right side out. Press.
Place the circle at the center of the daisy, on the traced line, and stitch in place along the outer edges. To reduce the green showing through here, I cut a third white circle about 1/4" smaller in diameter and sandwiched it in between the background and my center circle. Your pillow top is done!
I like to quilt my pillow fronts. I usually use muslin as a back to layer with the batting and top. I'm out of muslin at the moment, so I used some more Kona White (I buy it by the bolt so I have plenty!). I quilted a spiral in the center of the daisy and echo quilted inside and outside the daisy petals. I used Auriful #2021 for construction and quilting the daisy center and Aurifil #1231 for the rest of the quilting. The #1231 is a bit lighter than the Peridot, and I think it worked out well.
For the pillow back, I took the rest of the half yard cut of Peridot and cut about 6 1/2" off (the width of my ruler). I inserted the zipper between this section and the rest of the half yard. I trimmed the result to 16 1/2" square and sewed it, right sides together with the quilted front using a 3/8" seam on the sides and a 1/2" seam at the corners. My pillows often have "ears" that are too perky, so I wanted a slightly larger seam at the corners.
So, that's it for me! What have you been sewing with solids?